Ericsson SPR1100 Operations Instructions Page 198

  • Download
  • Add to my manuals
  • Print
  • Page
    / 300
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 197
Stream Processing and Networking
The user can enter the IP address of the SNTP server to be used, the default
address is 000.000.000.000, which indicates to the system that no SNTP server
has been defined, and therefore SNTP is disabled.
If an SNTP server is defined, and it fails to respond, then an SNTP Server Timeout
alarm will be raised. This alarm will be de-asserted either when an SNTP response
is received, or the SNTP functionality is disabled.
6.9 Simple Network Management Protocol (SNMP)
6.9.1 Supported Protocols
SNMP versions 1, 2c and 3 are supported, primarily for alarm trap handling. The
General Ericsson MIB is also supported.
Note: The unit does not support control via SNMP, all remote control is via HTTP
or HTTPS.
6.9.2 Operation
The unit’s SNMP functionality can be enabled or disabled, with up to five IP
addresses assigned for any SNMP Trap message to be sent. The default is
000.000.000.000, which causes the SNMP traps to be sent to the last SNMP
master. The SNMP community name can also be set.
The user can control which SNMP traps are generated. The options are;
Start Messages only
Fail and Start Messages only
All Traps
Table 6.7 SNMP Interface Parameters
Parameter Description
SNMP Read Community
The SNMP community name for read access. default =
public
SNMP Location Textual description of the location of the unit
SNMP Contact Name of the person responsible for this unit
SNMP Trap Community
The SNMP community name for read access. default =
private
SNMP Trap Destination
The destination IP address for SNMP trap messages. Up to
five destinations can be defined, but by default none are
assigned
SNMP Trap Alarm Level
Defines what events trigger the generation of an SNMP trap
2/1553-FGC 101 1400 Uen B
6-28
Page view 197
1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 299 300

Comments to this Manuals

No comments