Ericsson SPR1100 Operations Instructions download pdf (Page 109)

Web GUI Control

 Autorevert Delay – Selects autorevert delay, 0 – 255 seconds. The time taken

to enable an interface to participate in redundancy after the interface link up is

established. If set to 0, the switch happen immediately.

 Active Interface – Displays the current active interface.

 Line Speed – A drop-down menu specifying the line speed.

 Duplex Mode – Selecting Full Duplex allows bi-directional simultaneous

communications.

 Default MAC Address – Displays the default MAC address.

 IP Address – Enables entry of the IP address for the control port.

 Subnet Mask – Enables entry of the subnet mask for the control port.

 Gateway Address – Enables entry of the gateway address for the control port.

Physical control Port 1

 Port Type – displays the port type (Ethernet).

 Direction – displays port input or output type.

 Index – displays port index number.

 Default MAC Address – displays port default MAC address.

 Link Status – displays port link status (and speed).

 Link-up Time – displays the time that that link has been established.

 Tx Packets – displays number of IP packets transmitted.

 Rx Packets – displays number of IP packets received.

 IP Address – displays port IP address.

Configure > System > Network Configure > Control Interface Group > Physical

Control Port 2

To edit the parameters of Port 2, select the Physical Control Port 2 button from the

Control Interface Group page. The following page is displayed and contains user-

editable fields similar to those shown in Figure 5.30.

2/1553-FGC 101 1400 Uen B

5-27

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 299 300

No comments

Ericsson SPR1100 Operations Instructions Page 109