Technical Specification
B.2.2 IP Parameters
It is possible to configure the following IP parameters for the Control Port.
Table B.3 IP Parameters (Control Port)
Parameter Specification
IP Address xxx.xxx.xxx.xxx (Ipv4)
Network Mask xxx.xxx.xxx.xxx (Ipv4)
Gateway Address xxx.xxx.xxx.xxx (Ipv4)
Note: The front panel always provides a way of changing these settings to prevent
all control interfaces being disabled.
B.2.3 MAC Address
The MAC address of each Ethernet Control port can be assigned via the Static
Parameters table.
B.3 Data Ethernet Specification
B.3.1 Overview
The Ethernet Data ports support IEEE 802.3u auto-negotiation and parallel
detection. The auto-negotiation function can be disabled to force the line speed to
be either 100 Mbps or 1000 Mbps.
These ports support Auto-MDIX. This function can be disabled
Table B.4 Data Ethernet Connector
Item Specification
Connector type RJ-45 (100/1000BaseT)
Connector designation Ge 1/2 Ge 3/4
Pin outs
(Unused pins are not
connected)
Pin 1 - Rx/Tx A(+)
Pin 2 - Rx/Tx A (-)
Pin 3 - Rx/Tx B (+)
Pin 4 - Rx/Tx C (+)
Pin 5 - Rx/Tx C (-)
Pin 6 - Rx/Tx B (-)
Pin 7 - Rx/Tx D (+)
Pin 8 - Rx/Tx D (-)
2/1553-
FGC 101 1400 Uen B
B-4
Comments to this Manuals