Ericsson GDC-500H Installation Guide download pdf (Page 28)

iPECS eMG80

System DECT Installation Guide Issue 1.0

3.6 User Subscription/Unsubscription

3.6.1 System ID

A System ID is given to the iPECS eMG80 system attached to the wireless terminal for

identification. System ID, which is the Potable Access Rights Key (PARK), is written on the KSU.

The Authentication Code as well as System ID should be entered at only the Attendant Station

before subscribing the wireless terminal to the iPECS eMG80 system.

To display the System ID, perform the following Steps:

1. From the Attendant station, press [TRANS/PGM]; the [TRANS/PGM] LED will flash (60

IPM) and [ON/OFF] LED will be turned ON.

2. Dial 0#.

3. Press the FLEX4 button.

When modifying the System ID:

1. From the Attendant Station, press [TRANS/PGM]; the [TRANS/PGM] LED will flash (60

IPM) and [ON/OFF] LED will be turned ON.

2. Dial 0#.

3. Press the FLEX6 button.

4. Enter the System ID (PARK code, refer to key sequence description below).

5. When finished, press the [HOLD/SAVE] button; a confirmation tone will be heard.

CAUTION

Normally you should not change the system ID. If you should change it, please

contact Ericsson-LG or the local dealer in your country.

The key sequence of the PARK= LLP__________PC

 LL – Two digits decimal representation of PARK length (Bit count)

 P______P – 11 heximal digits representation of PARK

 C – Check digit, calculated as the sum of each digit in the input stream multiplied by

its position in the input stream, modulo of 11; if the result is 10, this is represented by *.

Conditions

1. The System ID must be programmed when the System is installed.

2. When System ID is programmed, all previously entered data related to wireless features

will be erased.

3. The initial PARK value is 00000000000000; the value will display in LCD at first.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 44 45

No comments

Ericsson GDC-500H Installation Guide Page 28