Ericsson 230i User Manual download pdf (Page 7)

6 Getting started

for

ercial

etwo

mount. Due to possible interference, do not place the cordless phone near

audio or video equipment.

3. If you place the base station on a wall, screw the wall mount to the wall.

4. Connect the telephone cable to the base station’s telephone socket and to

the ISDN network terminator. Connect the power cord to the power plug

socket of the base station.

5. Connect the desk stand to the base station or connect the base station to the

wall mount. Locate the lower hooks first.

For the desk stand, route the cables through the slots at the back.

6. Place the handset into the base station as shown in the illustration. Make

sure that the handset is switched off.

7. Plug the power adaptor into the wall socket.

The red light on top of the base station should now be on continuously. If

you see a red, flashing light, there is a fault with the telephone line

connection.

After a few minutes the handset will subscribe itself to the base station and

the red light on the top of the base station will go off.

8. Leave the handset in the base station for at least 3 hours to charge the bat-

tery for the first time.

When the battery is charged, the handset is ready for use. For more informa-

tion about charging the battery, please refer to “Battery” on page 9.

If subscription fails

Normally the handset automatically subscribes to the base station when the

cordless phone is installed. However if automatic subscription fails (the signal

strength indicator is not visible in the display), you have to manually sub-

scribe the handset to the base station see “Subscribing a DT200 handset to the

230i base station” on page 29.

Language

At this point you may wish to change the language of your handset.

Line

Power

Home 1

1 2 3 4 5 6 7 8 9 10 11 12 ... 44 45

No comments

Ericsson 230i User Manual Page 7