Ericsson RX8000 Series User's Guide download pdf (Page 12)

RX8200 Advanced Modular Receiver

4 Operating the Equipment From A Web Browser

4.1 Introduction

A PC Web Browser may be used to configure, control and monitor the Receiver.

The PC must be connected to either of the two IP control ports on the rear of the

receiver (labelled CONTROL 1 and 2). Before operation, the User Settings for the

control port must be entered via the system menu on the front panel.

If the receiver is connected to an existing network or is not on the same subnet as

the control PC then assistance from the network administrator may be required in

modifying the User Settings.

To assist with troubleshooting, the IP control ports will respond to ICMP PING

request messages.

More details on all receiver User Settings available on the Web Browser Interface

can be found in the Reference Guide.

4.2 Receiver Web Browser Interface

To use the receiver Web Browser Interface, the IP address assigned to the

receiver control port in the front panel system menu should be entered into the

address field of the Web browser.

Provided that the network is correctly configured, the following status page should

be automatically loaded and displayed.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

No comments

Ericsson RX8000 Series User's Guide Page 12