Ericsson RX8000 Series User's Guide download pdf (Page 18)

RX8200 Advanced Modular Receiver

5.4 Configuring the Video Output

!The unit will automatically decode the first video component that it finds

within the selected service.

!An alternative video component may be selected from the service tab on the

Web Control interface.

If the incoming video is successfully decoded then the status ‘OK’ should be

displayed on the appropriate page. Successfully decoded High Definition video will

be output from the connector marked “Video Component”. Successfully decoded

Standard Definition video will be output from the connector marked “CVBS”.

5.5 Configuring the Audio Outputs

!The unit will automatically decode the first two audio components that it finds

within the selected service.

!Alternative audio components may be selected from the service tab on the

Web Control interface

5.6 Configuring for Single-service Decryption

!If the service selected for video decode (see Section 5.3) contains encrypted

components these components will automatically be decrypted by the unit.

!The outgoing feed from the unit will contain these decrypted components.

5.7 Configuring for Multi-service Decryption

!When a feed containing more than one encrypted services is applied to the

unit, the first 24 services detected are automatically decrypted. A list of these

services can be found in the service table off front panel menu 4.

!This list may be modified from the CA tab on the Web Control interface.

NOTE

This is only applicable for units models that have Multi-service

Decryption licenses enabled.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Ericsson RX8000 Series User's Guide Page 18