Ericsson Orion Installation Manual download pdf (Page 34)

STEP 4 – MOUNT CONTROL UNIT AND RADIO

Control Unit Mounting (Remote Applications Only)

1. Use the bracket as a template and mark and drill the mounting holes. Be

sure to leave enough room at the rear of the control unit for the cable

connector. Refer to Figure 30 for control unit mounting bracket

installation.

2. Secure the mounting bracket using the four No. 10 x 3/4 self-tapping

screws supplied. (Use No. 10 x 1 ½ if needed.)

3. Secure the control unit to the bracket with the two 1/4-20 x 5/8 hex head

screws and lock washers provided.

Top Mount Bottom Mount

Figure 30: Control Unit Mounting Brackets

Pigtail Bracket

The Pigtail Bracket mounts the DB15 connector for easier user access. The

DB15 connector facilitates radio programming and keyloading by the

customer without the need to dismantle the radio or Control Unit. There are

two Pigtail brackets, one for use with the Control Unit and one for use with

the radio-mounting bracket. This section includes procedures to mount the

Pigtail Brackets in each of these configurations.

Control Unit Mounting

For Control Unit mounting, attach the pigtail bracket to the side of the Control

Unit bracket using existing mounting bracket hardware. The Pigtail Bracket

can be mounted to the left or right side of the Control Unit. Hardware Kit,

KT101533V6, contains Pigtail mounting bracket and hardware required to

attach Pigtail to bracket.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 79 80

No comments

Ericsson Orion Installation Manual Page 34