Ericsson T18di User's Guide download pdf (Page 15)

Getting Started 11

Complete the following procedures to set up your mobile phone for

the first time:

• Review the document conventions used in this guide by

referring to the “Document Conventions” chapter.

• Attach the belt clip to the phone by referring to the Attaching

the Belt Clip to Your Phone section in this chapter.

• Fully charge and condition your battery by referring to the

Charging Your Battery section in this chapter.

• Turn your phone On by referring to the “Basic Operations”

chapter.

Attaching Your Standard or Swivel Belt Clip

Your Ericsson mobile phone is equipped with either a standard or

swivel belt clip:

Standard Belt Clip

1 Remove the belt clip from the plastic bag.

2 Remove the flexible rubber plug from the top of the clip.

3 While making sure that the screw is going through both the plastic

clip and through the metal support guide, insert the screw into the

opening on the back of the phone.

4 Using a small Philips head screwdriver, turn

the screw clockwise until it is secure as

shown in the following illustration. Do not

over tighten the screw.

5 Inserting the two smaller prongs first,

replace the flexible rubber plug at the top of

the clip.

Swivel Belt Clip

1 Align the screw-in tab between the two

guides on the back of the phone, with the

thicker end on top.

2 Using a screwdriver, attach the tab to the

phone.

3 Place the swivel belt clip on your belt or

waistband.

4 Slide your phone, with tab, into the

swivel belt clip. To remove, press the release mechanism on the top

of the clip and slide the phone up and out of the clip.

Getting Started

Push to

release phone

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 83 84

No comments

Ericsson T18di User's Guide Page 15